[. . . ] (76 L) 39" (990 mm) tall drain tub or utility sink, sump pump and connectors (available from local plumbing suppliers) 2" (51 mm) diameter to 1" (25 mm) diameter Standpipe Adapter Part Number 3363920 Connector Kit Part Number 285835 Extension Drain Hose Part Number 285863 Connector Kit Part Number 285835 Drain Protector Part Number 367031 Connector Kit Part Number 285835 Optional tools: Flashlight Bucket Parts supplied: NOTE: All parts supplied for installation are in cardboard insert in the top of the washer. Drain hose too short Lint clogged drain LOCATION REQUIREMENTS Select proper location for your washer to improve performance and minimize noise and possible “washer walk”. Install your washer in a basement, laundry room, closet, or recessed area. [. . . ] 3 ELECTRICAL REQUIREMENTS INSTALLATION INSTRUCTIONS Before you start: remove shipping materials It is necessary to remove all shipping materials for proper operation and to avoid excessive noise from washer. It is recommended that a separate circuit breaker serving only this appliance be provided. N This washer is equipped with a power supply cord having a 3 prong grounding plug. N To minimize possible shock hazard, the cord must be plugged into a mating, 3 prong, grounding-type outlet, grounded in accordance with local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have the properly grounded outlet installed by a qualified electrician. N If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. N Check with a qualified electrician if you are not sure the washer is properly grounded. NOTE: To avoid floor damage, set washer onto cardboard before moving it and make sure lid is taped shut. Remove shipping base To avoid damaging floor, place cardboard supports from shipping carton on floor behind washer. If your washer includes a sound shield, please refer to the instructions included with the sound shield to install it at this time. Attach drain hose to drain port Remove tape from washer lid, open lid and remove cardboard packing tray from tub. Free power cord If clamp is not already in place on elbow end of drain hose, slide it over end as shown. Squeeze clamp with pliers and slide black elbow end of drain hose onto black drain port and secure with clamp. For a floor drain, remove the preinstalled drain hose form as shown in Step 7. [. . . ] HELPFUL TIP: You may want to prop up front of washer about 4" (102 mm) with a wood block or similar object that will support weight of washer. Tighten leveling feet Jam nut Not Level LEVEL Not Level On models with metal feet, when washer is level, use a 9/16" or 14 mm open-end or adjustable wrench to turn jam nuts counterclockwise on leveling feet tightly against washer cabinet. Q Check that shipping materials were completely removed from washer. [. . . ]